LEGALDIGMLEGALDIGM
    ← Code of Federal Regulations
    Beta
    16 CFR § 1505.8

    16 CFR § 1505.8 — § 1505.8 Maximum acceptable material temperatures.

    Beta. Legal information, not legal advice. LEGALDIGM is not a law firm. Check the official source for the current text.

    Analyze this law with AI
    § 1505.8 Maximum acceptable material temperatures. The maximum acceptable material temperatures for electrically operated toys shall be as follows (Classes 105, 130, A, and B are from “Motors and Generators,” Standard MG-1-1967 1 published by the National Electrical Manufacturers Association): 1 Copies may be obtained from: National Electrical Manufacturers Association, 155 East 44th Street, New York, NY 10017. Material Degrees C. Degrees F. Capacitors ( 1 ) ( 1 ) Class 105 insulation on windings or relays, solenoids, etc.: Thermocouple method 2 90 194 Resistance method 110 230 Class 130 insulation system 110 230 Insulation: Varnished-cloth insulation 85 185 Fiber used as electrical insulation 90 194 Class A Class B Class A Class B Insulation on coil windings of a.c. motors (not including universal motors) and on vibrator coils: In open motors and on vibrator coils—thermocouple or resistance method 2 100 120 212 248 In totally enclosed motors—thermocouple or resistance method 2 105 125 221 257 Insulation on coil windings of d.c. motors and of universal motors: In open motors: Thermocouple method 2 90 110 194 230 Resistance method 100 120 212 248 In totally enclosed motors: Thermocouple method 2 95 115 203 239 Resistance method 105 125 221 257 Phenolic composition 3 150 302 Rubber- or thermoplastic-insulated wires and cords 3 60 140 Sealing compound ( 4 ) ( 5 ) Supporting surface while the toy is operating normally 90 194 Wood and other similar combustible material 90 194 1 If the capacitor has no marked temperature limit, the maximum acceptable temperature will be assumed to be 65 °C. (149 °F.) for an electrolytic type and 90 °C. (194 °F.) for other than an electrolytic type. 2 The temperature indicated refers to the hottest spot on the outside surface of the coil measured by the thermocouple method. 3 The limitations on rubber- and thermoplastic-insulated wires and cords and on phenolic composition do not apply if the insulation or the phenolic has been investigated and found to have special heat-resistant properties, or if the insulation meets the thermal requirements. 4 40 less than melting point. 5 104 less than melting point.

    Related guides, FAQ and contract templates