Beta
14 CFR § 33.64
14 CFR § 33.64 — § 33.64 Pressurized engine static parts.
Beta. Legal information, not legal advice. LEGALDIGM is not a law firm. Check the official source for the current text.
Analyze this law with AI§ 33.64 Pressurized engine static parts.
(a) Strength. The applicant must establish by test, validated analysis, or a combination of both, that all static parts subject to significant gas or liquid pressure loads for a stabilized period of one minute will not:
(1) Exhibit permanent distortion beyond serviceable limits or exhibit leakage that could create a hazardous condition when subjected to the greater of the following pressures:
(i) 1.1 times the maximum working pressure;
(ii) 1.33 times the normal working pressure; or
(iii) 35 kPa (5 p.s.i.) above the normal working pressure.
(2) Exhibit fracture or burst when subjected to the greater of the following pressures:
(i) 1.15 times the maximum possible pressure;
(ii) 1.5 times the maximum working pressure; or
(iii) 35 kPa (5 p.s.i.) above the maximum possible pressure.
(b) Compliance with this section must take into account:
(1) The operating temperature of the part;
(2) Any other significant static loads in addition to pressure loads;
(3) Minimum properties representative of both the material and the processes used in the construction of the part; and
(4) Any adverse geometry conditions allowed by the type design.
[Amdt. 33-27; 73 FR 55437, Sept. 25, 2008; Amdt. 33-27, 73 FR 57235, Oct. 2, 2008]
