Beta
10 CFR § 431.344
10 CFR § 431.344 — § 431.344 Test procedure for measuring and determining energy efficiency of compressors.
Beta. Legal information, not legal advice. LEGALDIGM is not a law firm. Check the official source for the current text.
Analyze this law with AI§ 431.344 Test procedure for measuring and determining energy efficiency of compressors.
(a) Scope. This section is a test procedure that is applicable to a compressor that meets the following criteria:
(1) Is an air compressor;
(2) Is a rotary compressor;
(3) Is not a liquid ring compressor;
(4) Is driven by a brushless electric motor;
(5) Is a lubricated compressor;
(6) Has a full-load operating pressure greater than or equal to 75 pounds per square inch gauge (psig) and less than or equal to 200 psig;
(7) Is not designed and tested to the requirements of the American Petroleum Institute Standard 619, “Rotary-Type Positive-Displacement Compressors for Petroleum, Petrochemical, and Natural Gas Industries;”
(8) Has full-load actual volume flow rate greater than or equal to 35 cubic feet per minute (cfm), or is distributed in commerce with a compressor motor nominal horsepower greater than or equal to 10 horsepower (hp); and
(9) Has a full-load actual volume flow rate less than or equal to 1,250 cfm, or is distributed in commerce with a compressor motor nominal horsepower less than or equal to 200 hp.
(b) Testing and calculations. Determine the applicable full-load package isentropic efficiency (η isen,FL ), part-load package isentropic efficiency (η isen,PL ), package specific power, maximum full-flow operating pressure, full-load operating pressure, full-load actual volume flow rate, and pressure ratio at full-load operating pressure using the test procedure set forth in appendix A of this subpart.
[82 FR 1102, Jan. 4, 2017]
